Hand Carved Colt 1911 Wooden Grips - Full Size M1911 Grip

Ant Hill > Pistol Accessories > 1911 Hand Carved Grips

COLT 1911 COMMANDER AND GOVERNMENT SIZE GRIPS

Hand carved wooden 1911 pistol grips.

These are unique grips and will vary slightly from the photos.

PAIR OF COLT M1911 WOOD GRIPS

PGT-08

Pair of Full Size Teak Wood 1911 Pistol Grips with a Textured Finish

DIAMOND AND CHECKERED

£15.00p per pair

Textured finish.

Weighs approx 36 grams.

PGT-10

Pair of Full Size Wood 1911 Pistol Grips with Ornate Decorative Finish

ORNATE

£16.80p per pair
PAIR RESERVED, BY REQUEST
Decorative design.

Weighs approx 38 grams.

PGT-22

LIONS

£18.00p per pair

Decorative design.

Weighs approx 36 grams.

PGT-27

Pair of Full Size Wood Colt 1911 Pistol Grips with Hand Carved Diamond Checker Pattern Finish

COLT

£18.00p per pair

Textured finish.

Weighs approx 32 grams.

PGT-12

VERITAS AEQUITAS

£18.00p per pair

Decorative design.

Weighs approx 38 grams.

PGT-14

1911 TEXT

£18.00p per pair

Textured finish.

Weighs approx 38 grams.

Condition: New

Beautiful handmade grips for Colt 1911 pistols.

Made from Teak ("king of the woods") a dense, close grained hardwood.

Full size Government / Commander handgun grips.

The fixing holes are 6.5mm diameter and are 78mm from centre to centre.

GENERAL INFORMATION:

They have a cutout on the back of the top left grip, for standard safety, but if you have ambi-safety (of which there are a few different designs), then you will likely need to cut out a section of the back of the grips to allow space for the ambidextrous safety.

Standard cut grips have bevelled ends (used on most guns).

Magwell cut grips have flat ends to butt-up against the standard thickness magwells for a flush finish.
There are others but those are the main two end cut types.

The end of grip cut outs are for the main spring housing pin.

The small notch on the front edge of the right side grip is for the magazine catch fitting.

Finish ~ buffed wax to beautifully highlight the texture.

The checkers and diamonds are hand cut, not CNC, for a sharper look.

We have been told that the ornate grips didn't fit the GSG 1911 rimfire or the Colt CQBP Co2 pistol,
this could also apply to the other grips.

They need a small area removing from the back of the grip to fit over the Co2 capsule on the Remington P-1911 RAC.

They should also fit Weihrauch HW45 pistols, but may need a little adaption.

Also available ~ Smooth Finish Wooden 1911 Grips and Decorative 1911 Grip Screws.