ANT SUPPLIES LTD

Greatly reduces the possibility damage caused by the bolt battering the recoil pin.

Usually one of the first upgrades to the Ruger 10/22.
Twin pack of steel recoil shock buffers with Viton rubber covers.

To replace the 1/4" steel bolt stop pin, at the back of the receiver.
To avoid metal on metal contact from the bolt, for noise reduction.

Quick and easy installation, following safe gun handling procedures.
You will need a screwdriver, suitable pin punches and non-marring hammer.

Remove the stock and original steel 1/4" bolt stop pin.
Slide in the new buffer pin and reassemble.

The buffer is unaffected by oils or solvents.
Approx 31mm long.


Should be compatible with: Ruger 10/22, SR-22 and Charger rifles.

Three piece Ruger 10/22 stainless steel pin set.

1 x Viton Bolt Buffer Pin (No.1).
2 x Receiver Cross Pin (No.2).

Eight piece complete Ruger 10/22 stainless steel pin set.

1 x Viton Bolt Buffer Pin (No.1).
2 x Receiver Cross Pin (No.2).
1 x Hammer Pivot Pin (No.3).
1 x Ejector Pivot Pin (No.4).
1 x Trigger Pivot Pin (No.5).
1 x Magazine Latch Pivot (No.6).
1 x Trigger & Sear Assembly Short Pin (No.7).

Trigger and sear assembly pin is used during the assembly process only.

Ruger 10/22 compatible single shot bolt block accessory.

Allows your semi auto sporting rifle to be uses as a single shot, ideal for training new shooters.

Magnetic bolt block ~ three super strong aerospace design magnets.

Install and remove in a second.

It should fit without adaption, but may need a little filing or sanding for a perfect fit.

High visibility red finish.

Overall length ~ 44mm.

Thickness ~ 4mm.